☎ Contact Us · +90 (850) 303 27 83
Yapı Kataloğu light+intelligent süper eng

Waterproofing System | HFA Respect

Overview
Entech HFA Respect system is a hot applied bitumen-rubber based water insulation system. It is a homogeneous mixture of refined asphalts, mineral fillers and synthetic rubber materials. It is applied by melting at a suitable temperature (195 degrees) in special melting boilers with ELECTRIC MELTER 500 mixer produced by Entech, pouring and pulling with a squeegee.

Technical Specifications

  • - It creates a hard, flexible and self-renewing water insulation layer.
  • - It creates a 100% solid monolithic layer and does not contain volatile substances etc.
  • - Its usage cost is lower than water-based systems. For example, an application of 4.5 kg/m2 leaves a 3.75 mm net film in Entech HFA Respect System. In water-based systems, an application of approximately 6.0-6.5 kg/m2 is required to obtain this amount of dry film.
  • - It is poured at high temperatures, fills all gaps, adheres completely and does not allow water to flow in the event of a possible puncture.
  • - Since no curing is required after application, it is not affected by environmental effects, and it is sufficient for the hot application to cool down to be put into use.
  • - It adheres very strongly to metal-concrete surfaces and forms a monolithic waterproofing layer
  • - It is acid and alkali resistant.
  • - It has high crack bridging properties.
  • - It is a high viscosity material.
  • - It is suitable for cold climate applications. (-18 C)

Product Features

Usage Location
Is it an outdoor product?
Yes
Documents, Certificates and Compliance
Does it comply with EN / ISO standards?
Yes
Is it moisture resistant?
Yes
Is it acid resistant?
Yes
Is it rain resistant?
Yes
Product Physical Properties
Colour
Black
Binder / base type
Bitumen-Based

Application Areas

  • - Toured - non-toured terraces
  • - Garden terraces
  • - Underground - above ground parking lot flooring
  • - Open-cover tunnel flooring
  • - Viaduct flooring
  • - Since it is not a UV resistant product, it should be covered appropriately after application.
Bitumen, Asphalt and Tar Based Waterproofing
Request a quote for this product
Waterproofing System | HFA Respect
Waterproofing System | HFA Respect
Entech
STEP 1 / 2
Phone or email — enter at least one
⏱ avg. reply ~4 hours · straight to the company representative